Hybrid 2 Proof Of Concept Edition Support

Intro

FAQ

1. Can I used XCS or Laserbox Basic?
   • Sorry, no, no xTool software
2. Will there be a version that is compatible with xTool software?
   • Not very likely, no
3. How do I turn off the red crosshairs?
   • You can’t.  Sorry!  Production version will have this option
4. Can I mount my rotary directly to the Hybrid2 so it’s always in the same place?
   • Sure! 
5. What is expected to be in the later Production version?
   • Ideas being kicked around:
     • Production version of Devil1
     • Better solution for cable management
     • More finished appearance

Software

lbdev: Needed to set up your machine with Lightburn

lbset: Need to reconfigure you machine back to defaults if needed

Firmware flash files:

Flash utility – (Windows) Use this to flash the firmware to the Devil1

Flash utility installation guide

Flash utility (Mac) – Use this to flash the firmware to the Devil1

Firmware file – This is what the flash utility will use for flashing the Devil1  (Last updated: 12/22/22)

 

Installation

Mechanical Assembly Manual

Wiring Setup:

1. Connect stepper motor cable from Devil1 to Hybrid2 stepper motor
2. Connect module cable from Devil1 to module
3. Install module on gantry using clamping mount
4. Connect supplied power cord to Devil1
5. Connect USB cable to Devil1
6. Power on Devil1

Lightburn Setup:

1. In Lightburn, on the Laser tab, click the Devices button
2. Click the Import button
3. Select the lbdev file for Hybrid2 (see Software, above)
4. Click Ok button

Hybrid 2 should now appear in your Devices list

 

Troubleshooting

• When I home, the module moves to the right instead of the left and bangs into the stopper
  • Using the directional arrows in Lightburn or on the Devil1 LCD screen, check if left and right movement is correct
    • If no:
      • Do Edit – Machine Settings
      • Go to Outputs section
      • Toggle X Direction Invert option to the opposite of what it is set for
        • If it was True, set to false and vice versa
      • Click the Write button
      • Close Machine Settings window
      • Check the left right movement again
        • If all is good, click the Home button and verify that Hybrid2 now homes correctly 
    • If yes:
      • Do Edit – Machine Settings
      • Go to Outputs section
      • Toggle X Homing direction invert option to the opposite of what it is set for
        • If it was True, set to false and vice versa
      • Click the Write button
      • Close Machine Settings window
      • Check the left right movement again
        • If all is good, click the Home button and verify that Hybrid2 now homes correctly