WeCreat Vision 20W Replacement Laser Module Cooling Fan

WeCreat Vision 20W Replacement Laser Module Cooling Fan

Has the cooling fan in your WeCreat Vision 20W laser module stopped working, become noisy, or started operating intermittently?

Geeks At Large has you covered with a ready-to-install replacement cooling fan for the WeCreat Vision 20W laser module.

This fan is configured specifically as a replacement for the original Vision 20W module fan, including the correct electrical connector and wire configuration. There’s no need to buy a generic fan and then cut, splice, solder, or adapt its wiring to your machine.

Replace the original fan, plug in the connector, and get your laser back into service.

Designed for the WeCreat Vision 20W Laser Module

Cooling is an important part of maintaining a diode laser module. The laser produces substantial heat while engraving and cutting, and the module fan provides airflow to help remove that heat.

WeCreat identifies the fan on top of the Vision laser head as part of the machine’s cooling system and provides specific troubleshooting procedures for a laser module fan that isn’t operating correctly.

A failing cooling fan may become noisy, run intermittently, slow down, or stop altogether. If your fan has reached the end of its useful life, replacing the fan itself can provide a straightforward repair option.

Correct Connector – No Splicing Required

A generic cooling fan may have similar physical dimensions but still require modifications before it can be installed in your laser.

This replacement is supplied with the appropriate two-wire connector already installed, as shown in our product photographs.

That means:

• No cutting the original connector from your old fan
• No soldering
• No wire splicing
• No crimping a replacement connector
• No modifying a generic fan harness

Simply disconnect the original fan and install the replacement.

Keep Your Vision 20W Working

Cooling fans are mechanical components that operate whenever they’re needed to move air through the laser module. Bearings, motors, wiring and connectors can eventually wear or fail.

A replacement module fan is therefore a useful repair part to keep available—particularly for Vision machines that see regular production use.

WeCreat’s own troubleshooting documentation includes inspection of the fan, fan wire and connector when diagnosing a Vision laser module fan that isn’t operating.

Replacing a failed or damaged fan allows you to address the cooling component itself rather than trying to modify an unrelated generic fan for the application.

Installation

The Vision 20W cooling fan is accessible from the top of the laser module. WeCreat’s service procedure calls for powering down the machine and removing the four screws at the top of the 20W laser head before removing the fan cover and accessing the fan.

Always disconnect power before servicing your laser.

Compatibility

Designed for:

WeCreat Vision 20W laser engraver / 20W laser module

This listing is specifically for the Vision 20W module cooling fan. Please verify your machine and laser module before ordering.

Package Includes

1 × Replacement WeCreat Vision 20W Laser Module Cooling Fan

Laser module, laser engraver, mounting hardware and other components are not included unless specifically stated.

Geeks At Large Laser Replacement Parts

Geeks At Large specializes in practical replacement parts and accessories that help keep laser engravers operating instead of replacing larger assemblies unnecessarily.

This WeCreat Vision 20W replacement cooling fan is supplied ready for its intended application with the appropriate wiring and connector already installed.

Replace the failed fan, plug it in, and get back to engraving.