K40 C02 Rotary Switch | Omtech, Vevor, Monport Etc

K40 C02 Rotary Switch,  the easy way to swap between doing flat engraving/cutting and rotary work.  No cable swapping, no wear and tear on connectors or cables.  Instead, a simple switch which toggles between without all the fuss.  Cables are plugged in and left plugged in, no need to connected or disconnect them unless you want to.  And should you want to, the harness gives extra room to get your fingers on the cable connection.  The housing is all metal, no printed parts here.

This is not a brand specific product! Got your K40 from Monport, Omtech, Vevor, or some other place? No problem, the K40 is an open spec design and our rotary switch fits them all. Installation is a snap: one cable plugs swaps in for the Y stepper cable on the control board.  The Y stepper cable plugs into the marked connector on the switch harness.  Your rotary plugs into the remaining switch harness connector.  To keep the switch in place, double sided adhesive tape used to bond the switch to your K40 frame wherever it’s out of the way but also easy to get at with your fingers.  That’s it, hardware install is done and the K40 C02 Rotary Switch is ready to use.  Leave your rotary connected all the time and flip the switch when you’re ready to use it.  Please see the dedicated product support page for more details.