Elegoo Phecda Rotary Switch, the easy way to swap between doing flat engraving/cutting and rotary work. No cable swapping, no wear and tear on connectors or cables. Instead, a simple all metal switch that toggles between without all the fuss. Cables are plugged in the left plugged in, no need to connected or disconnect them unless you want to. And should you want to, the harness gives extra room to get your fingers on the cable connection. Installation is a snap: one cable plugs swaps in for the Y stepper cable on the control board. The Y stepper cable plugs into the marked connector on the switch harness. Your rotary plugs into the remaining switch harness connector. To keep the switch easily accessible, two of the existing frame screws of your Elegoo Phecda are used hold the switch housing under the front of the frame where it’s out of the way but also easy to get at with your fingers. That’s it, hardware install is done and the Elegoo Phecda Rotary Switch is ready to use.
Like all of our Elegoo Phecda products, checkout the dedicated product support page for more details. Installation time is estimated at about 5 minutes at the most.
Brent White (verified owner) –
Quality product, professional service, simple install. Takes the hassle out of swapping that motherboard wire out and risking damage. The kit is such a good price value it saves you from hunting your own parts, spending more time and money in the long run and supports our community R&D.
b.back (verified owner) –
simple install. I used a longer rotary so had to make a adaptor cable, but it worked perfectly and makes life easier. I installed the limit switches as well and designed my own camera mount, so my laser is perfect now. Thanks for your quality products.