TwoTrees Rotary Switch Support
Intro
FAQ
- How does TwoTrees Rotary Switch work?
- When you want to use do flat engraving, put the switch in the Y position. When you want to do rotary work, move the switch to the R position. The final position, “-” does nothing.
Software
No additional software required, this is purely hardware.
Installation
- Power off machine
- Access the machine controller
- Unplug Y axis stepper motor cable from Y axis port on controller
- Pass the switch cable plug and switch connector marked “Y” through the hole in the controller housing (same hole the other wires are passing through)
- Install the switch cable plug into the Y axis port on controller
- Plug Y axis stepper motor into the switch cable connector marked “Y”
- Reassemble controller housing
- Using the included screws and T nuts, install the switch to the TwoFrees frame in a place that it’s easily accessible but not in the way of the laser
- Plug rotary cable into remaining switch cable
- Using the two included cable clips, organize the cables so that they are out of the way and will not tangle with the laser
Common TwoTrees Controllers
Troubleshooting
-
- If there is further TwoTrees Rotary Switch Support needed, please get in touch!