Elegoo Phecda Rotary Switch is your solution for easily swapping between flat and rotary engraving. Easy to setup, easy to use for the Elegoo Phecda laser engraver.
FAQ
How does Elegoo Phecda Rotary Switch work?
When you want to use do flat engraving, put the switch in the Y position. When you want to do rotary work, move the switch to the R position. The final position, “-” does nothing.
Software
No additional software required, this is purely hardware.
Installation
Power off Elegoo Phecda
Unplug Y axis stepper motor cable from Y axis port Elegoo Phecda controller
Plug switch cable into the Y axis port Elegoo Phecda controller
Plug Y axis stepper motor into the switch cable connector marked “Y”
Plug rotary cable into remaining switch cable
Remove two frame screws in the front right corner of the Elegoo Phecda
Using the two included screws to mount the switch to the frame
Using the two included cable clips, organize the cables so that they are out of the way and will not tangle with the Y stepper motor driveshaft
All done!!
Troubleshooting
Name:
Type:
View
Crop Image
If your machine is down and you have orders to fill, USPS Ground Advantage is the worst choice Dismiss