When you want to use do flat engraving, put the switch in the Y position. When you want to do rotary work, move the switch to the R position. The final position, “-” does nothing.
Software
No additional software required, this is purely hardware.
Installation
Power off Creality Falcon
Access the Creality Falcon controller by removing the 6 screws
Unplug Y axis stepper motor cable from Y axis port Creality Falcon controller
Pass the switch cable plug and switch connector marked “Y” through the hole in the controller housing (same hole the other wires are passing through)
Install the switch cable plug into the Y axis port Creality Falcon controller
Plug Y axis stepper motor into the switch cable connector marked “Y”
Reassemble controller housing
Using the included screws and T nuts, install the switch to the Creality Falcon Frame in a place that it’s easily accessible but not in the way of the laser
Plug rotary cable into remaining switch cable
Using the two included cable clips, organize the cables so that they are out of the way and will not tangle with the laser
All done!!
Troubleshooting
If there is Falcon Rotary Switch Support needed, please get in touch!
Name:
Type:
View
Crop Image
If your machine is down and you have orders to fill, USPS Ground Advantage is the worst choice Dismiss