Your Cart

TwoTrees Rotary Switch Support

TwoTrees Rotary Switch Support

twotrees-rotary-switch-kit

Intro

TwoTrees Rotary Switch is your solution for easily swapping between flat and rotary engraving.  Easy to setup, easy to use for the TwoTrees laser engraver.
 

FAQ

  • How does TwoTrees Rotary Switch work?
    • When you want to use do flat engraving, put the switch in the Y position.  When you want to do rotary work, move the switch to the R position.  The final position, “-” does nothing.

Software

No additional software required, this is purely hardware.  

Installation

  • Power off machine  
  • Access the machine controller 
  • Unplug Y axis stepper motor cable from Y axis port on controller
  • Pass the switch cable plug and switch connector marked “Y” through the hole in the controller housing (same hole the other wires are passing through)
  • Install the switch cable plug into the Y axis port on controller
  • Plug Y axis stepper motor into the switch cable connector marked “Y” 
  • Reassemble controller housing
  • Using the included screws and T nuts, install the switch to the TwoFrees frame in a place that it’s easily accessible but not in the way of the laser

twotrees-rotary-switch-2020-install

twotrees-rotary-switch-2020

  • Plug rotary cable into remaining switch cable
  • Using the two included cable clips, organize the cables so that they are out of the way and will not tangle with the laser

All done!!

Common TwoTrees Controllers

twotrees-rotary-switch-ts2
TwoTrees TS2

 

twotrees-rotary-switch-tts
TwoTrees TTS

 

twotrees-rotary-switch-ttspro
TwoTrees TTS-Pro

Troubleshooting

    • If there is further TwoTrees Rotary Switch Support needed, please get in touch!

 

Crop Image